Nokia of America Corporation BBTRX-06 Benutzerhandbuch
Result
The RRH mounting bracket is attached to the wall or to the unistrut.
Install RRH on wall
CAUTION
Personal Injury
The bolts on the RRH can pinch and damage your fingers.
Keep fingers clear when lowering the RRH into position.
Perform the following procedure to install the RRH on a wall or to the unistrut on a wall.
...................................................................................................................................................................................................
1
Insert Gin Boom into top of the wall mount bracket.
...................................................................................................................................................................................................
2
Attach the hoisting mechanism chains.
...................................................................................................................................................................................................
3
If you have not already done so, attach lifting harness to the two lifting points (eye bolts)
of the RRH.
of the RRH.
...................................................................................................................................................................................................
4
Carefully raise the RRH into position using the hoisting mechanism, if required.
...................................................................................................................................................................................................
5
Loosely attach the two side top M10 hex bolts, flat washers, and lock washers to the RRH
as supplied with the wall mounting kit. Do not tighten yet, install only halfway. Tape the
washers to the bolts.
as supplied with the wall mounting kit. Do not tighten yet, install only halfway. Tape the
washers to the bolts.
Important! When lifting the RRH, do not rest the bottom side on the ground.
...................................................................................................................................................................................................
6
At the upper corners of the RRH, pull the washers to the sides. Position to the M10 hex
bolts on the RRH in the top mounting slots of the wall bracket.
bolts on the RRH in the top mounting slots of the wall bracket.
...................................................................................................................................................................................................
7
Remove the sling.
...................................................................................................................................................................................................
8
Install the two bottom side M10 hex bolts, flat washers, and lock washers through the
wall mounting bracket.
wall mounting bracket.
Remove tape from top hardware.
Transport, mount, and ground the RRH
Mounting instructions
Mounting instructions
To mount hardware to wall
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
5-14
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
September 2012