Nokia of America Corporation BBTRX-06 Benutzerhandbuch
To mount hardware to pole with pole bands
Purpose
This section describes the procedures to be followed when installing the RRH on a 152
mm to 380 mm diameter pole with pole brackets.
mm to 380 mm diameter pole with pole brackets.
WARNING
Fall hazard
Falls can occur when working at heights resulting in serious personal injury or death.
To prevent a fall when working at heights (ladder, scaffold, manlift, roof etc.) follow safe
work practices and wear appropriate fall protection equipment.
work practices and wear appropriate fall protection equipment.
Before you begin
The following mounting hardware is required to mount up to the RRH on a pole:
• Pole mounting bands (qty. 2)
• Pole brackets (qty. 2)
• Wall Mounting Brackets
• M10 bolts, lock washers, and flat washers (four).
• Pole mounting bands (qty. 2)
• Pole brackets (qty. 2)
• Wall Mounting Brackets
• M10 bolts, lock washers, and flat washers (four).
Measure and mark pole and pole bands
Perform the following procedure to measure and mark the upper and lower pole band
locations and the pole bands.
locations and the pole bands.
...................................................................................................................................................................................................
1
Use a tape measure to determine and mark the position of the upper and lower pole bands
350 mm (14.37 in) apart for RRHs. Refer to specific cell site engineering information for
measurement details.
350 mm (14.37 in) apart for RRHs. Refer to specific cell site engineering information for
measurement details.
...................................................................................................................................................................................................
2
Measure the circumferencee (distance around the pole) at the heights of the bands to be
installed.
installed.
...................................................................................................................................................................................................
3
Measure the distances you calculated in Step 2 on the pole bands from the fixed retainer
extrusion as shown in the following figure.
extrusion as shown in the following figure.
Transport, mount, and ground the RRH
Mounting instructions
Mounting instructions
To mount hardware to pole with pole bands
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
5-18
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
September 2012