Nokia of America Corporation BBTRX-06 Benutzerhandbuch

• lock washers (qty. 12), flat washers (qty. 12), for M10 bolts
• M10 nuts (qty. 4)
• Wall Mounting Brackets (equipped with RRH).

Measure and mark pole and attach pole brackets

...................................................................................................................................................................................................

Use tape measure to determine and mark the position of upper pole bracket.

...................................................................................................................................................................................................

Attach upper pole bracket to the wall mount bracket using two 80mm long M10 hex bolts,
lock washers, flat washers. Insert bolts through inner holes of the wall mount bracket
panel.

Repeat for lower pole bracket

...................................................................................................................................................................................................

Insert a 300 mm, M10 long hex bolt, equipped with lock washer, and flat washer, through
the upper left-most hole in the bracket panel, through the attached pole bracket.

...................................................................................................................................................................................................

Insert opposite bracket over threaded portion of the 300 mm bolt, and secure with flat
washer, lockwasher, and hex nut.

...................................................................................................................................................................................................

Adjust to estimated pole diameter

...................................................................................................................................................................................................

Lift sub-assembly to marked height

...................................................................................................................................................................................................

Insert 300 mm long, M10 hex bolt, lock washer, and flat washer through the right- most
upper hole in mounting bracket panel, through the attached pole bracket and the opposite
bracket, and secure with lock washer, flat washer and hex nut

...................................................................................................................................................................................................

Equally tighten hardware

...................................................................................................................................................................................................

Install opposite end of lower pole bracket using 300 mm, M10 long hex bolts, lock
washers, and flat washers

Transport, mount, and ground the RRH
Mounting instructions

To mount hardware to pole with pole brackets

....................................................................................................................................................................................................................................

September 2012

Alcatel-Lucent – Proprietary

Use pursuant to applicable agreements

5-23