Nokia of America Corporation BBTRX-06 Benutzerhandbuch
To install RRH on pole weldment assemblies
Purpose
This section describes the procedures to be followed when installing the RRH to pole
weldment assemblies.
weldment assemblies.
WARNING
Fall hazard
Falls can occur when working at heights resulting in serious personal injury or death.
To prevent a fall when working at heights (ladder, scaffold, manlift, roof etc.) follow safe
work practices and wear appropriate fall protection equipment.
work practices and wear appropriate fall protection equipment.
Before you begin
Make sure you have read and understood the section
Install RRH on pole weldment assemblies
Perform the following procedure to install the RRH on the mounting hardware.
...................................................................................................................................................................................................
1
Attach the hoisting mechanism chains.
...................................................................................................................................................................................................
2
If you have not already done so, attach the lifting harness to the two lifting points (eye
bolts) of the RRH.
bolts) of the RRH.
...................................................................................................................................................................................................
3
Carefully raise the RRH into position using the hoisting mechanism, if required.
...................................................................................................................................................................................................
4
Loosely attach the two side top M10 hex bolts, flat washers, and lock washers to the RRH
as supplied with the wall mounting kit. Do not tighten yet, install only halfway. Tape the
washers to the bolts.
as supplied with the wall mounting kit. Do not tighten yet, install only halfway. Tape the
washers to the bolts.
Note: When lifting the RRH, do not rest the bottom side of the RRH on the ground.
...................................................................................................................................................................................................
5
At the upper corners of the RRH, pull the washers to the sides. Position the M10 hex bolts
on the RRH in the top mounting slots of the bracket.
on the RRH in the top mounting slots of the bracket.
Transport, mount, and ground the RRH
Mounting instructions
Mounting instructions
To install RRH on pole weldment assemblies
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
September 2012
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
5-25