E F Johnson Company 2424140 Benutzerhandbuch
MISCELLANEOUS
55
Invald Key - The key pressed by the user was not
valid for the current situation.
valid for the current situation.
Invld Ch - The channel entered by the user in keypad
programming is not valid.
programming is not valid.
Key Fail - The encryption key required by the current
selected group/channel is not valid.
selected group/channel is not valid.
Kypd Lockd - The keypad lock function is active and
key presses are not accepted in this mode.
key presses are not accepted in this mode.
Kset Fail - The encryption key set chosen by the user
is not valid.
is not valid.
List Only - Direct entry of a unit ID or phone number
is disabled.
is disabled.
Locked - A selector lock command has been received
and zone and channel changes are not accepted.
and zone and channel changes are not accepted.
Lost Signl - Signal from the infrastructure has been
lost during an interconnect call.
lost during an interconnect call.
Low Power - The current channel is strapped to low
power and that the user can not select high power at
this time.
power and that the user can not select high power at
this time.
Msg Failed - The current channel is strapped to low
power and that the user can not select high power at
this time.
power and that the user can not select high power at
this time.
Narrow - The current conventional channel is
programmed as a narrow channel.
programmed as a narrow channel.
No Ack - The radio did not receive an ACK for the
current signaling attempt.
current signaling attempt.
No Edit - The current list is not able to be edited.
No Encrypt - Encryption is not available for the
selected channel.
selected channel.
No List - No list is available for the selected channel.
No Message - No message is programmed for trans-
mission.
mission.
No Reply - Radio cloning failed due to no response.
No Service - OTAR service is not available.
No Site - No site with a verified ID is yet on the
dynamic site list.
dynamic site list.
No Keys - No keys are available for the key select
function.
function.
Out Of Rng - This error indicates no control channel
has been found for trunking operation.
has been found for trunking operation.
Parms Fail - The checksum of the profile / user
parameters does not match the calculated checksum.
This indicates that there is an error in the parameters
file. This message only occurs if the redundant copy of
the parameters is also corrupt or is unable to be used.
parameters does not match the calculated checksum.
This indicates that there is an error in the parameters
file. This message only occurs if the redundant copy of
the parameters is also corrupt or is unable to be used.
Rekey Fail - This error indicates a failure in a
rekeying process.
rekeying process.
Rx Only - The selected channel is Rx only.
Sts Failed - No acknowledgement was received while
sending a status report.
sending a status report.
Timeout - A time out has occurred in attempting the
current function.
current function.
Too Hot - The mobile has passed the TOO HOT
temperature threshold. Under these conditions the
radio will not allow Tx.
temperature threshold. Under these conditions the
radio will not allow Tx.
Tx Timeout - The Tx time-out timer has expired and
Tx has been terminated.
Tx has been terminated.
VOLTAGE HI - The input voltage to the mobile is
too high.
too high.
VOLTAGE LO - The input voltage to the mobile is
too low.
too low.
Write Fail - The radio is unable to write to the
EEPROM.
EEPROM.
7.3 SYSTEM OPERATOR PROGRAMMING
As noted several times in this manual, program-
ming determines the availability and specific operation
of many features. This usually refers to the program-
ming performed by the PCConfigure programmer
of many features. This usually refers to the program-
ming performed by the PCConfigure programmer