E F Johnson Company 2425341 Benutzerhandbuch

22

channels/talk groups. More information follows on 
selecting and editing standard scan lists.

Determining Channels in Standard Scan List

Channels in the conventional standard scan lists 

are determined as follows. Channels in the 
SMARTNET/SmartZone/P25 Trunked standard scan 
lists are indicated only when editing a list (see 
“Editing a Standard Scan List”).

1. Enable Standard scanning as described in Section 

4.11.2. Also select the scan list if applicable as 
described in the following “Selecting a Standard 
Scan List” description. 

2. Select the desired zone and then scroll through the 

channels by rotating the Select switch. When the 
displayed channel is in the scan list (scanned 
normally), the   symbol is displayed next to the 
zone number as shown in the following illustration.

Selecting a Standard Scan List

Conventional Operation - The scan list is user 
selectable by the SCAN option switch. Refer to 
Section 5.11 for more information.

SMARTNET/SmartZone/P25 Trunked 
Operation - The scan list can be temporarily 
changed if the Scan (List) Select option switch is 
programmed. Refer to Section 6.12.3 for more 
information.

Editing a Standard Scan List

If the SCN ED (Scan Edit) option switch is 

programmed, standard scan lists can be user edited as 
follows (all operating modes). Changes are permanent 
(cycling power does not reselect a default condition).

1. Make sure that both standard and radio wide scan-

ning are off (the rotating   icon is not indicated in 
the right status display). Select a conventional, 
SMARTNET/SmartZone/P25 Trunked channel 
corresponding to the scan list being edited.

2. Select the scan list edit mode by pressing the SCN 

ED option switch. This mode is indicated by a 
triangle in the upper left corner of the display (see 
Figure 2-3 on page 10.). 

3. If applicable, select the list to be edited by rotating 

and then pressing the Select switch. The selected 
scan list is indicated as “LIST x” as described in the 
preceding section. If user programming is disabled 
on a list (conventional channels only), “NO EDIT” 
is momentarily displayed and it cannot be edited.

4. Select the channel you want to add or delete by 

rotating the Select switch. After the last channel in 
the current zone is displayed, the first valid channel 
in the next zone is displayed and vice versa. Lists are 
limited to 256 channels. If an attempt is made to add 
more than 256, “LIST FULL” is displayed and a 
channel must be deleted before another can be 
added.

5. If the selected channel is in the scan list (scanned), 

the   symbol is displayed next to the zone number 
as just described. To change the scan list status of 
the displayed channel, press the Select switch. 

With conventional channels only, if the selected 
scan list is programmed with fixed priority 
channel(s), the next press of the Select switch makes 
the current channel the priority channel indicated by 
“P” in the left status display next to the zone 
number. If dual priority channels are used, pressing 
the Select switch again makes it the second priority 
channel indicated by “2” in the left status display. 
Then pressing the Select switch again takes the 
channel out of the scan list. Refer to Sections 5.11.3 
and 5.11.4 for more information on priority channel 
sampling.

6. To exit this mode and save the changes, press the 

SCN ED option switch again.

Scan List Indicator

Chnl

No.