E F Johnson Company 2425M80 Benutzerhandbuch

Draft 02 - Sep 1 2015

9-9

The following messages are defined in the radio. Other messages will be displayed as a 
number. Contact EFJ engineering for more information on a “numbered” reject message.

5

Corrupt Parms

The parameters checksum or other data is corrupted. 

6

Unused

7

DSP Fail

This error indicates that the DSP failed to complete its startup 

procedure at powerup. 

8

RX Backend Fail

There is a communication failure between the DSP and the back 

end ADC on the RF deck.

9

HC08 Init Fail

The HCO8 was not initialized correctly and cannot be accessed 

for flash reads and writes,  etc.

10

Channel Fail

The radio has been programmed with more channels than it 

optioned for.

11

Encryption Fail

This error indicates that the main processor and the encryption 

module have failed to complete their startup procedure at 

powerup.

12

Bad ESN

This error indicates that the ESN of the radio is not valid. This 

error is usually only seen in the factory when first programming 

brand new logic boards.

“ID Invalid”

The ID of the subscriber is invalid.

“Target Invalid”

The ID of the target is invalid.

“ID Disabled”

The ID of the substriber is disabled or not allowed to access the 

system.

“Target Disabled”

The target ID is disabled or not allowed to access the system.

“Invalid Group”

The takgroup is not valid.

“Disabled Group”

The talkgroup is disabled or not allowed on the system.

“Feature Disabled”

The attempted feature is not allowed on the system.

“Clear Only”

Secure calls are not allowed for the target ID or are not allowed for the 

current group.

“Secure Only”

Clear calls are not allowed for the target ID or are not allowed for the 

current group.

“Over Budget”

Interconnect dollar limit exceeded by user.

“Not Allowed Site”

The subscriber’s ID is not allowed or the current
talkgroup is not allowed on the site.

“Override Invalid”

There is not call busy override.