Futaba Corporation CGY760R-24G Benutzerhandbuch
13
12
Do not cut or bundle the receiver antenna wire.
Do not bend the coaxial cable. It causes damage.
Do not bend the base of the antenna or drop it from the base side of
the antenna onto the ground and do not give a shock. It causes damage.
Keep the antenna as far away from the motor, ESC and other noise
sources as you possibly can.
CARBON FUSELAGE PRECAUTION:
WARNING
You must leave 30mm at the tip of the antenna fully exposed. The
exposed antenna should be secured so that
it cannot move around or back inside of your
aircraft.
it cannot move around or back inside of your
aircraft.
CONNECTOR INSERTION PRECAUTION:
WARNING
Do not connect the connector by mistake
as shown on the right.
BEFORE EACH FLIGHT:
WARNING
Keep away from conductive materials to avoid short circuits.
If it does not operate properly during operation test before use or
use, stop using it.
Always check the transmitter and receiver battery voltage to ensure
they have enough remaining capacity to complete the l ight.
Coni rm that the CGY760R is operating in the correct mode.
ABOUT BATTERIES:
WARNING
Newer high end servos and other radio equipment are capable of
placing large demands on the power systems in use today. When using
a regulator you must ensure that the regulator is capable of supplying
the current demands of the equipment you have selected. In addition
to this make sure the wiring and switch you have selected are capable
of handling high current draws.
a regulator you must ensure that the regulator is capable of supplying
the current demands of the equipment you have selected. In addition
to this make sure the wiring and switch you have selected are capable
of handling high current draws.
*The servo current draw can be up to 50% higher on a l ybarless helicopter. Always en-
sure your receiver battery is fully charged before each l ight.
sure your receiver battery is fully charged before each l ight.
ABOUT CONNECTOR:
Insert the connector such as sensor, servo, connection cord, battery
etc. surely.
*If it is not securely inserted all the way in, it may come off due to vibration during l ight
and there is a danger of falling.
and there is a danger of falling.
ABOUT WIRING:
Please i x at the appropriate position so that the continuing cord
rub against the corner of the metal or carbon frame and the covering
will not break.
will not break.
ABOUT VIBRATION ISOLATION AND WATERPREEFING:
The CGY760R is fixed with a dedicated mounting pad with good
condition and the helicopter performs sufficient anti-vibration mea-
sures so as not to receive strong vibration at the time of l ight. Also, if
there is a risk of watering, place it in a plastic bag and take waterproof
measures.
sures so as not to receive strong vibration at the time of l ight. Also, if
there is a risk of watering, place it in a plastic bag and take waterproof
measures.
ON FLIGHT PRECAUTION:
Always exit programming mode before attempting to l y the model.
.
Gyro operating precautions:
Gyro
The CGY760R requires 5-10 seconds to initialize when the power is
turned on. Do not move the helicopter and do not move the tail rotor,
aileron and elevator sticks during this initialization or the gyro may not
initialize properly. Once the initialization process has been completed
the swash servos and tail servo will move several times indicating that
the CGY760R is now ready for l ight.
aileron and elevator sticks during this initialization or the gyro may not
initialize properly. Once the initialization process has been completed
the swash servos and tail servo will move several times indicating that
the CGY760R is now ready for l ight.
Do not connect either a switch
or battery in this manner.
or battery in this manner.
Do not connect either a switch
or battery in this manner.
or battery in this manner.
DANGER
DANGER