Nihon Kohden Corporation ZM-930PA Benutzerhandbuch
38
Operator's Manual ZM-920PA/930PA
Connecting SpO
2
Probe to the Transmitter
Connect the probe to the SpO
2
socket on the transmitter.
CAUTION
••••• Do not shake or swing the
transmitter while holding the cables
connected to the transmitter. The
transmitter may come off and injure
someone or damage surrounding
instruments.
connected to the transmitter. The
transmitter may come off and injure
someone or damage surrounding
instruments.
••••• Hold the connector when
connecting/disconnecting the
probe. If you disconnect the SpO
probe. If you disconnect the SpO
2
probe pulling the cable, it damages
the cable.
the cable.
Attaching the Probe to the Patient
For details, refer to the operator’s manual of each probe.
WARNING
• When using the TL-201T finger probe, do not fasten the probe and
cable to the finger by wrapping with tape. This may cause burn,
congestion or pressure necrosis from poor blood circulation.
congestion or pressure necrosis from poor blood circulation.
• When using probes other than the TL-201T finger probe, to avoid
poor circulation, do not wrap the tape too tight. Check the blood
circulation condition by observing the skin color and congestion at
the skin peripheral to the probe attachment site. Even for short-
term monitoring, there may be burn or pressure necrosis from
poor blood circulation, especially on neonates or low birth weight
infants whose skin is delicate. Accurate measurement cannot be
performed on a site with poor peripheral circulation.
circulation condition by observing the skin color and congestion at
the skin peripheral to the probe attachment site. Even for short-
term monitoring, there may be burn or pressure necrosis from
poor blood circulation, especially on neonates or low birth weight
infants whose skin is delicate. Accurate measurement cannot be
performed on a site with poor peripheral circulation.