Nihon Kohden Corporation ZM-930PA Benutzerhandbuch

Operator's Manual ZM-920PA/930PA

sensor cable because this can damage the cable.

• Do not immerse the disposable probe in detergents or water. If the

probe adhesive surface gets wet, adhesiveness becomes weak
and the probe cannot be attached to the skin.

• Before using the TL-260T multi-site Y probe, be sure to attach the

probe to the sponge attachment tape S or L. Do not use the probe
without the sponge attachment tape attached. Using the probe
without the sponge attachment tape causes incorrect
measurement and may injure the skin at the attachment site.

• When fixing the TL-260T multi-site Y probe with the sponge

attachment tape, confirm that the adhesive part of the tape is not
on the skin. The adhesive may cause oversensitive symptoms on
the skin such as redness or itch. If the adhesive touches the skin,
remove it carefully and slowly because neonatal skin is very
delicate.

• Do not use a dirty sponge attachment tape. The measurement

value may be incorrect.

• Use the sponge attachment tape S and L only with the specified

products.

• Refer to the probe instruction manual for details.

Starting Measurement

When monitoring starts, SpO

and pulse waveform are sent to the monitors and

SpO

data and pulse level bar graph are displayed on the transmitter LCD.

You can turn off the display of SpO

data and pulse level bar graph on the LCD.

Refer to the “Turning SpO

Data and Pulse Level Bar Graph Display On/Off”

section.

CAUTION

When the probe is attached on an appropriate site with sufficient
circulation and the error message confirming the probe attachment
repeatedly appears, the probe may be deteriorated. Replace it with
a new one.