Nihon Kohden Corporation ZM-940PA Benutzerhandbuch
Operator's Manual ZM-940PA
19
2.
Insert three new or fully charged batteries into the
battery case observing the correct polarity.
battery case observing the correct polarity.
3.
Close the cover.
NOTE
Remove the batteries before disposing of the
transmitter.
transmitter.
Situations Requiring Battery Replacement
Replace the batteries when any of the following occurs.
• The transmitter LCD displays the “
Replace the batteries when any of the following occurs.
• The transmitter LCD displays the “
” or “
”mark.
• The transmitter generates a constant alarm (continuous “peep” sound).
• The transmitter LCD does not display anything when the power is turned on.
• The monitor displays the battery replacement message on the screen.
• The transmitter LCD does not display anything when the power is turned on.
• The monitor displays the battery replacement message on the screen.
Battery Condition Indication
The battery condition is indicated as follows.
The battery condition is indicated as follows.
Indication
Condition
Receiving Monitor
Fully charged battery
Batteries are full. There is no indication on
the monitor.
the monitor.
Batteries are low. Replace
batteries.
Batteries are low. NIBP cannot
be measured. Replace batteries.
batteries.
Batteries are low. NIBP cannot
be measured. Replace batteries.
Message requiring battery replacement is
displayed.
displayed.
No
indication
Dead batteries
No signal can be transmitted to the monitor.
There is no indication on the monitor.
There is no indication on the monitor.