HP 5185-3843 Benutzerhandbuch
5-8 Troubleshooting Problems
Unable to Communicate with the Wireless Print Server
—During Initial Setup:
Verify the following:
Your wireless computer is configured to match the default wireless network settings on
the print server:
the print server:
Communication Mode:
Ad Hoc
Network Name (SSID):
hpsetup
Encryption (WEP):
[disabled or turned off]
Note
The Network Name (SSID) is case-sensitive; be sure to use lowercase characters.
If you make a error in entering the SSID, encryption, or authentication configu-
ration, you may be unable to connect to the access point and join the network.
If you make a error in entering the SSID, encryption, or authentication configu-
ration, you may be unable to connect to the access point and join the network.
If your connection fails after entering one of these configuration items, then you
must reset the print server to factory-default settings (“cold reset”), according to
the procedure on page 5-14), then reenter the correct configuration.
must reset the print server to factory-default settings (“cold reset”), according to
the procedure on page 5-14), then reenter the correct configuration.
The print server is turned on and operating properly (print a configuration page).
There are fewer than six devices total on the ad hoc network (with SSID
hpsetup
).
There is no access point in the vicinity that is configured with SSID
hpsetup
.
There are not multiple print servers that are being configured at the same time. If so,
turn all off except the one you want to configure.
turn all off except the one you want to configure.