HP 5185-3843 Benutzerhandbuch
5-14 Troubleshooting Problems
Resetting to Factory Defaults (“Cold Reset”)
Once you configure the HP print server, the configuration settings are retained in memory
unless you manually reset them to factory defaults. If you lose communications with the
HP Jetdirect print server, or it fails to operate properly, you may need to reset the print
server to its factory-default configuration. This is called a “cold reset”.
unless you manually reset them to factory defaults. If you lose communications with the
HP Jetdirect print server, or it fails to operate properly, you may need to reset the print
server to its factory-default configuration. This is called a “cold reset”.
Procedure
To reset the print server configuration to factory defaults, follow these steps:
1. Unplug the power module from the back of the print server.
2. While holding down the test button
on the back of the print server, plug the power
module back into the print server and continue to hold down the test button button for
about five seconds. Any user-configured settings will be erased.
about five seconds. Any user-configured settings will be erased.
Note
When this step is done, the print server responds exactly like it was fresh from
the factory. This 802.11b print server will be in ad hoc mode after this procedure;
it will scan for a network with an SSID of
the factory. This 802.11b print server will be in ad hoc mode after this procedure;
it will scan for a network with an SSID of
hpsetup
to join. Until it finds a
network, it will continue scanning with an IP address 0.0.0.0. Once a network
is established by completing step 4 below (for example by having a laptop
establish a network with a name of
is established by completing step 4 below (for example by having a laptop
establish a network with a name of
hpsetup
), it will go to the default IP address
192.0.0.192.
If an X.509 certificate is installed for SSL/TLS secure embedded Web services,
it will be saved over a cold reset.
it will be saved over a cold reset.
3. Print a Jetdirect configuration page to confirm that factory-default values you expect