Cyclevision Pty Ltd CVHC0101 Benutzerhandbuch
14
15
Battery LED status lights
Battery recharge will commence immediately once the USB cable is
plugged into the rear USB port, and the rear Battery LED status lights will
illuminate indicating the battery is recharging.
Charger Requirements: Output current: DC 5V 2.0A
If using a Power Bank to charge the Cyclevision Helmet, turn ON the
Helmet and make sure it is in RECORDING mode, then plug-in the
Power Bank connection.
Note: If charging the Cyclevision Helmet by Power Bank whilst in
RECORDING mode, the charging speed will be very slow due to
insufficient charging current given from the Power Bank.
The Cyclevision Helmet can be topped up with a Power Bank once the
Helmet has been turned on and is operating correctly.
Turn the Cyclevision Helmet ON let the 10 second start sequence
complete. When both red LEDs are flashing, plug in your remote Power
Bank to the rear micro USB port, the Helmet will now be accepting a
power top up whilst continuing to record.
The Cyclevision Helmet has a 3250Ma battery. The useable life can
be extended approximately by 1000Ma for every hour. For example, a
2000Ma power bank will extend the runtime for approximately 2 hours if
fully charged.
WARNING!
DO NOT USE A POWER BANK TO CHARGE THE BATTERY IN
DIRECT SUNLIGHT. DURING CHARGING, THE TEMPERATURE
SHOULD NOT BE OVER 45°C.
Note: Both USB ports are open to the weather. They are both sealed
inside the helmet and are of waterproof nature so no damage can be
done if water is sprayed into this area.
WARNING!
DO NOT PLUG THE USB CABLE INTO BOTH THE FRONT AND REAR
USB PORTS AT THE SAME TIME UNDER ANY CIRCUMSTANCES!
THIS WILL DAMAGE THE ELECTRONIC CIRCUITRY.
DO NOT SWITCH CAMERA ON WHILST HELMET IS CHARGING AS IT
MAY CAUSE CAMERA TO OVERHEAT.
CHARGING CYCLEVISION HELMET
CHARGING WITH A POWER BANK