Cyclevision Pty Ltd CVHC0101 Benutzerhandbuch

Powering On: Press the On/Off button on the back of the Cyclevision

Helmet for at least 1.5 seconds to power on. The camera start sequence

will commence which takes approximately 10 seconds. Once the start

sequence has been activated do not press the ON/OFF button again until

the start sequence has fully completed.

The rear camera status light located to the top right hand side of the rear

camera lens tube will illuminate as a solid Red light for approximately 4

seconds. Additionally, the front camera status light will illuminate red and

follow the same start sequence as the rear.

Powering Off: To turn the helmet OFF hold the power button down for

2 seconds then release. The helmet will take 3 seconds and then shut

down, all lights will turn off indicating power OFF.

Power ON / OFF

POWERING ON / OFF CYCLEVISION

Once the ON/OFF button has been pressed, the red front and rear

camera status lights are illuminated, and all 4 Blue LED battery level

indicators will illuminate for approximately 4 seconds, then revert back to

display the remaining useable battery charge.

When fully charged the 3250 mA battery will run the helmet continually

for approximately 2.5 hours without WIFI running.
4 LED lights = 4/4 full charge

3 LED lights = 3/4 charge

2 LED lights = 1/2 charge

1 LED light = 1/4 charge

BATTERY LEVEL INDICATOR