Gemalto Inc. PR01523 Benutzerhandbuch
Intelligent Document Reader AT10Ki User Guide
Maintenance
Page 34 of 41
The glass assembly slides towards the rear, be careful not to damage or remove the rubber gasket
seal. The status/RFID PCB should stay in place.
seal. The status/RFID PCB should stay in place.
3. Check that the status/RFID PCB is correctly located before reassembly. It should sit inside the
reader and be pushed forward into the retaining clips (left picture arrowed). The close-up view
shows (1) the PCB correctly positioned against the clip and (2) correctly seated into the reader
chassis.
shows (1) the PCB correctly positioned against the clip and (2) correctly seated into the reader
chassis.