EnGenius Technologies ENH220EXT Benutzerhandbuch

16

To attach the ENH220EXT to a wall using wall 
mounting kit.

1.  Mark the four locations of the mounting holes on the 

flat mounting surface.

2.  Drill a 37 mm deep 8 mm hole in the markings and

hammer the bolts into the openings.

3.  Place the lock and flat washers on the four hex cap screws

and drive the screws to attach the bracket to the back of 
the Access Point.

4.  Tighten  the  flat  washers  to  secure  the  bracket  to  the

mounting surface.