Panasonic Corporation of North America 9TAK-SAP14 Benutzerhandbuch
DIP switch setting
Switch
No
Name
Function
On
Off
Switch1
1
Setting
Selecting “For ONLY Alert” or ”For sound broadcast”.
For ONLY Alert*
For sound
broadcast
broadcast
2
Version display
To display the software version by LED lighting
pattern as the power is turned on.
pattern as the power is turned on.
Activated
Deactivated *
3
Initialize Factory setting
Initialize all internal setting to the
factory-shipments State
factory-shipments State
Activated
Deactivated *
4
Transmission output
control
control
It allows adjusting the RF power output at
installation by command input via RS232
installation by command input via RS232
High(mode2)
Low(mode1)*
5
Unused
―
-
-
6
Unused
―
-
-
7
Unused
―
-
-
8
Unused
―
-
-
Switch2
1
DECT AP Group number
setting
setting
Selection of Group ID between Receiver and DECT
AP.
AP.
0-127 of Group ID
2
3
4
5
6
7
8
Unused
-
-
-
*default setting
Note:
Note:
DIP switch 1 can select the operation mode of each function equipped in this unit.
The settings of this switch are updated at the time of turning on the power.
From No.1 to No7 of DIP switch 2 are used for selection of group ID.
The settings of this switch are updated at the time of turning on the power.
From No.1 to No7 of DIP switch 2 are used for selection of group ID.
(It is used at the time of installation of DECT-AP and a receiver.)