Shenzhen Chuangwei Electronic Appliance Tech Co. Ltd. 101S Benutzerhandbuch

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:
‐

Reorient or relocate the receiving antenna.

‐

Increase the separation between the equipment and receiver.

‐

Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.
‐

Consult the dealer or an experienced radio/TV technician for help.

This device was tested for typical body‐worn operations with the back of the

handset kept 10 mm from the body.

To maintain compliance with FCC RF exposure requirements, use accessories

that maintain a 10 mm separation distance between the user's body and the

back of the handset. The use of belt clips, holsters and similar accessories

should not contain metallic components in its assembly. The use of

accessories that do not satisfy these requirements may not comply with FCC

RF exposure requirements, and should be avoided.

During SAR testing, this device is set to transmit at its highest certified power

level in all tested frequency bands, and placed in positions that simulate RF

exposure in usage near the body with the separation of 10 mm. Although the

SAR is determined at the highest certified power level, the actual SAR level of

the while operating can be well below the maximum value. This is because

the device is designed to operate at multiple power levels so as to use only

the power required to reach the network. In general, the closer you are to a

wireless base station antenna, the lower the power output.

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.

Device types Tablet PC (FCC ID: 2AABK-101S) has

also been tested against this SAR

limit.The highest SAR value reported under this standard during product

certification for use when properly worn on the body is 0.841W/kg.