E Measuring Device Limited USB01 Benutzerhandbuch
9
4.6 Data Transfer
When a dimension is measured, by pressing the “TRANSFER” key switch (6), the
reading on the display unit will be transferred to your computer via the USB
receiver (8). You should hear a “DING” sound from your computer to confirm the
data has been transferred and received.
reading on the display unit will be transferred to your computer via the USB
receiver (8). You should hear a “DING” sound from your computer to confirm the
data has been transferred and received.
4.7 Power Off
When the measuring tape is left idle for 60 seconds, the equipment will be
automatically powered off.
automatically powered off.
4.8 Battery Replacement
When the battery level of the measuring tape drops to the pre-set low limit, the
battery-low warning signal (9) on the display unit will flash. The measuring tape can
be used for a few more hours. However, you should prepare to replace the old
batteries with new batteries.
battery-low warning signal (9) on the display unit will flash. The measuring tape can
be used for a few more hours. However, you should prepare to replace the old
batteries with new batteries.