E Measuring Device Limited USB01 Benutzerhandbuch
8
4.4 Set Zero
When the tape is fully retracted, the reading on the display unit should be “0.0”. In
case, when the tape is fully retracted and the reading on the display unit is not
“0.0”, you should press the ZERO key switch (5). The reading on the display unit will
be set to “0.0”.
case, when the tape is fully retracted and the reading on the display unit is not
“0.0”, you should press the ZERO key switch (5). The reading on the display unit will
be set to “0.0”.
4.5 USB Receiver
Plug in the USB receiver (8) into any USB port of your computer. The LED on the
receiver will light on.
Note : The measuring tape and USB receiver are one-to-one matching pair before
leaving factory. If you have more than one set of this product used in your site, do
not mix the USB receiver with another measuring tape. The label on the USB
receiver and the label inside the battery compartment of the measuring tape
should carry the same serial number)
Install and startup your database program as per Chapter 5. Select the subject you
want to inspect and measure.
receiver will light on.
Note : The measuring tape and USB receiver are one-to-one matching pair before
leaving factory. If you have more than one set of this product used in your site, do
not mix the USB receiver with another measuring tape. The label on the USB
receiver and the label inside the battery compartment of the measuring tape
should carry the same serial number)
Install and startup your database program as per Chapter 5. Select the subject you
want to inspect and measure.