UTStarcom MSG2000 Benutzerhandbuch
Page
11-255
CC06786-11B
Confidential and Proprietary
Firmware Upgrades
1
4
AB
AB
Preliminary
If neither eth0 nor eth0.4094 is assigned a valid IP address, set static IP
address for the interface.
If the IPMC is using Base Channel A, configure eth0:
If the IPMC is using Base Channel A, configure eth0:
If IPMC is using Base Channel B, configure eth0.4094:
e.
Download the firmware and update the Flash
The firmware can be put on a HTTP or FTP server.
Or
3.
Post-upgrade, if there is non-default fabric switch config:
a.
a.
Restore the file
Then, update the file denoted by the key "fswitchCfg",
by default, it's /etc/fswitchCfg.def.
Make sure the file is the same as it was before the upgrade.
Make sure the file is the same as it was before the upgrade.
b. Reconfigure the fabric switch
11.3.3 Showing, Switching, and Rebooting Boot Banks
Login to IPMC Linux command line then use "showboot" to show boot bank
information.
root@cnode-pp50-nboot:~ ifconfig eth0 10.4.50.34 netmask 255.255.0.0
root@cnode-pp50-nboot:~ route add default gw 10.4.0.254
root@cnode-pp50-nboot:~ ifconfig eth0.4094 10.4.50.34 netmask 255.255.0.0
root@cnode-pp50-nboot:~ route add default gw 10.4.0.254
root@cnode-pp50-nboot:~ fwup -f pp50-ipmc-v2.3.0b00/pp50-ipmc-v2.3.0b00.tgz
-s 10.3.7.204
root@cnode-pp50:~ fwup -f http://10.3.7.204/pp50-ipmc-v2.3.0b00/pp50-ipmc-
v2.3.0b00.tgz
root@cnode-pp50:~ fwup -f ftp://10.3.7.204/pp50-ipmc-v2.3.0b00/pp50-ipmc-
v2.3.0b00.tgz
Note:
The Firmware will be updated to two Flash bank automatically, and
system will reboot and run the new release
root@cnode-pp50-nboot:~ cnodekv fswitchCfg
root@cnode-pp50-nboot:~ vi /etc/fswitchCfg.def
root@cnode-pp50-nboot:~ fswitch reload config
root@cnode-pp50:~ showboot
System was booted from bank 1.
The active bank version is: v2.4.0r00
The backup bank version is: v2.3.4b01