Vital Home Systems LLC 1060 Benutzerhandbuch
P a g e
| 2
© 2015 - 2016 Vital Home Systems, LLC
1
3
Wireless Control Panel
Overview Model: VHS-1060
I. Identifying Parts on the Wireless
Control Panel
Control Panel
FRONT VIEW
Green/Red LED – Power Indicator
Green indicates the Power Status.
Green
Green indicates the Power Status.
Green
LED ON indicates Power ON.
Green LED flash indicates AC failure.
RED indicates Program / Learn / Range Test
Mode.
Red LED ON indicates Program / Learn Mode.
Red LED flash indicates Range Test Mode.
Mode.
Red LED ON indicates Program / Learn Mode.
Red LED flash indicates Range Test Mode.
Green – Cellular Signal Indicator
LED OFF indicates not connected to Cellular
network.
Green LED ON indicates Wireless Control Panel
connected to cellular network
LED OFF indicates not connected to Cellular
network.
Green LED ON indicates Wireless Control Panel
connected to cellular network
Yellow LED – Fault Indicator
The Yellow LED will light up when any fault
situation is detected, then turn off when all
fault conditions are restored.
The Yellow LED will light up when any fault
situation is detected, then turn off when all
fault conditions are restored.
NUMERIC KEY
SET KEY
Press this key for setting the telephone
numbers.
Press this key for setting the telephone
numbers.
CLR KEY
Press this key to exit Program Mode and return
to Normal Mode.
Press this key to exit Program Mode and return
to Normal Mode.
7
TEST KEY
While in Program Mode, press this key to enter
TEST Mode.
TEST Mode.
8
ACK KEY
Press this key to stop the voice Alarm after
alarm is sounded and it will stop the SMS from
going out if pressed prior to voice alarm. This
key may also be used for deleting a digit,
canceling the selection, aborting the current
application and returning to the Normal Mode,
etc.
It may also be used to stop playing the local
voice message.
alarm is sounded and it will stop the SMS from
going out if pressed prior to voice alarm. This
key may also be used for deleting a digit,
canceling the selection, aborting the current
application and returning to the Normal Mode,
etc.
It may also be used to stop playing the local
voice message.
When there is Fault situation indicated by
Yellow LED ON, pressing “ACK” will play the
corresponding voice message for 30
seconds or till CLR is pressed.
corresponding voice message for 30
seconds or till CLR is pressed.
When there is no Fault, pressing “ACK” will
give no response.
# KEY
Press this key to dial #
Press this key to dial #
KEY
Press this key to delay dial for three (3) seconds
Press this key to delay dial for three (3) seconds
Speaker
SMS LED – Flashes Red when sending SMS from
Wireless Control Panel
Wireless Control Panel
Side and Rear Views
Power – 5V Micro USB Jack and Battery Switch
DC 5V Micro USB and Battery Switch cover.
DC 5V Micro USB and Battery Switch cover.
Wall Mounting Bracket
4
5
6
8
9
2
1
2
3
4
5
6
7
8
9
0
*
#
SET
CLR
TEST
ACK
13
13
14
14