Vubiq Networks Inc. V10G-L Benutzerhandbuch
13
Vubiq HaulPass V10g User Manual
© 2018 Vubiq Networks, Inc. All Rights Reserved
3.0 Installation Instructions
3.1 Operating Modes
The HaulPass V10g units ship ready to operate in 10 Gbps mode. To operate the 1000Base-T or 1000Base-X ports,
refer to Section 5.1 to switch the units to 2.5 Gbps mode and enable the internal switch.
refer to Section 5.1 to switch the units to 2.5 Gbps mode and enable the internal switch.
The management unit is available through the 1000Base ports in either 10 Gbps or 2.5 Gbps mode at 198.166.68.2
for the TX Low and 198.166.68.3 for the TX High. In 10 Gbps mode, the port traffic in the 1000Base ports is not
transmitted over the RF link. To change the address of the management unit, refer to Section 5.2.
for the TX Low and 198.166.68.3 for the TX High. In 10 Gbps mode, the port traffic in the 1000Base ports is not
transmitted over the RF link. To change the address of the management unit, refer to Section 5.2.
Note: After installation, periodically check the Vubiq Networks website at
a firmware update available. If there is an update available, it should be installed. Refer to Section 5.4.
3.2 Unpacking the HaulPass V10g
Each terminal ships in a separate box. All contents of the terminal kit will be in each box. Upon opening, please
inspect the final quality control document and Quick Start Guide prior to continuing. Remove the top foam insert to
access the V10g terminal. The remaining accessories are underneath the V10g foam insert (See Figure 1).
inspect the final quality control document and Quick Start Guide prior to continuing. Remove the top foam insert to
access the V10g terminal. The remaining accessories are underneath the V10g foam insert (See Figure 1).
Figure 1. HaulPass V10g Packaging