Vubiq Networks Inc. V10G-L Benutzerhandbuch
18
Vubiq HaulPass V10g User Manual
© 2018 Vubiq Networks, Inc. All Rights Reserved
3.5 HaulPass V10g Ports
The HaulPass V10g ports are illustrated in Figure 9.
Figure 9. HaulPass V10g Ports
48VDC. This port is used to power up the V10g with an external power supply that is not a POE injector.
1000Base-T / POE++. This port is an RJ45 connector and is Port 1 for the Ethernet switch. It doubles as a power
port with a POE++ injector. It is shared with the 1000Base-X port to the internal switch. They cannot both be used
for Ethernet at the same time. However, you can power the device with a POE++ through the RJ45 connector and
use the 1000Base-X port for Ethernet if there is no Ethernet traffic on the R45 port.
port with a POE++ injector. It is shared with the 1000Base-X port to the internal switch. They cannot both be used
for Ethernet at the same time. However, you can power the device with a POE++ through the RJ45 connector and
use the 1000Base-X port for Ethernet if there is no Ethernet traffic on the R45 port.
1000Base-T. This is an RJ45 connector and is Port 2 for the Ethernet switch.
1000Base-X. This port is an SFP connector and is Port 1 for the Ethernet switch. It is shared with the P1 1000Base-
T port to the internal switch. They cannot both be used for Ethernet at the same time. However, you can power the
device with a POE++ through the RJ45 connector and use the 1000Base-X port for Ethernet if there is no Ethernet
traffic on the R45 port.
T port to the internal switch. They cannot both be used for Ethernet at the same time. However, you can power the
device with a POE++ through the RJ45 connector and use the 1000Base-X port for Ethernet if there is no Ethernet
traffic on the R45 port.
10000Base-X. This is an SFP+ port that bypasses the switch for communications. Having Ethernet traffic on this
port disables the internal switch.
port disables the internal switch.
3.6 Power over Ethernet++ Modules
The Vubiq HaulPass V10g ships with a Microsemi 9501GR Power over Ethernet++ (PoE++) injector for powering
the Vubiq HaulPass V10g terminal. The power to the V210g terminal travels over a CAT5E / CAT6 cable that is
plugged into terminal P1, 1000Base-T. The PoE++ module accepts AC Power from 100 to 240 VAC at 50 or 60 Hz.
The port labeled DATA PWR OUT (closest to the power LED) should be connected to the V10g. The port labeled
DATA IN should be connected to your network.
the Vubiq HaulPass V10g terminal. The power to the V210g terminal travels over a CAT5E / CAT6 cable that is
plugged into terminal P1, 1000Base-T. The PoE++ module accepts AC Power from 100 to 240 VAC at 50 or 60 Hz.
The port labeled DATA PWR OUT (closest to the power LED) should be connected to the V10g. The port labeled
DATA IN should be connected to your network.
The user may use a different PoE device such as a network switch provided the device is PoE++ and can supply 45
watts of power at 48 volts.
watts of power at 48 volts.
If the user would like to power the terminal with DC Power the 48VDC port should be used.
It is possible to have redundant power supplies by using both PoE++ and the 48 VDC ports simultaneously.