Hiro Inc. H50296 Benutzerhandbuch

Software Installation for Windows8.1

Step 1: Insert Wireless PCI express adapter Installation CD into CD-ROM drive, 

            open the CD-ROM and double click Setup.exe to install PCI express driver.

Step 2: Select “I accept the terms of the license agreement” and click Next to 

            continue.

Step 3: Click “Install driver and Ralink WLAN Utility” and clink Next to continue.

Step 4: Click “Install” to continue.

Step 5: Please wait for a while for installing process.

Step 1: Double click on Wireless Utility in the system tray.

Configuring Wireless Network

Step 6: Click Finish to finish installation.

Please insert the wireless adatpter to you PC before driver installation.

For PCI/PCI-E adapter

Computer will prompt you to install driver 

after the adapter has been inserted. 

Please refer to the steps in “Instruction 

of Install LAN Adapter Driver”

300Mbps Wireless N PCI-E Adapter

Information in this docutment is subject to change without prior notice.

Copyrights 2015 by HIRO All rights reserved. Website: http://www.hiroinc.com

Step 2: You will see the following screen. Click on the button “Available Networks       ”, 

            double click the network you want to connect in the list of Available Networks 

            and click Next button      .  

Step 3: Enter the network key if it is necessary and click Next button      to finish. 

Step 4: To check the connection, you will see the IP address and Mask of your 

            computer, point your mouse to the utility icon in the system tray and it will 

            show Status: “Good”.       

H50212

H50212

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the following 

measures: 

—Reorient or relocate the receiving antenna. 

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which the 

    receiver is connected. 

—Consult the dealer or an experienced radio/TV technician for help. 

This device complies with FCC radiation exposure limits set forth for an uncontrolled 

environment and it also complies with Part 15 of the FCC RF Rules. This equipment 

must be installed and operated in accordance with provided instructions and the 

antenna(s) used for this transmitter must be installed to provide a separation distance 

of at least 20 cm from all persons and must not be co-located or operating in conjunction 

with any other antenna or transmitter. End-users and installers must be provided with 

antenna installation instructions and consider removing the no-collocation statement.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions:  (1) this device may not cause harmful interference, and (2) this device 

must accept any interference received, including interference that may cause undesired 

operation. 

Any changes or modifications not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment.

Model No.: H50296