Hiro Inc. H50296 Manual Do Utilizador
Software Installation for Windows8.1
Step 1: Insert Wireless PCI express adapter Installation CD into CD-ROM drive,
open the CD-ROM and double click Setup.exe to install PCI express driver.
Step 2: Select “I accept the terms of the license agreement” and click Next to
continue.
Step 3: Click “Install driver and Ralink WLAN Utility” and clink Next to continue.
Step 4: Click “Install” to continue.
Step 5: Please wait for a while for installing process.
Step 1: Double click on Wireless Utility in the system tray.
Configuring Wireless Network
Step 6: Click Finish to finish installation.
Instruction of Install WLAN Adapter Driver
Please insert the wireless adatpter to you PC before driver installation.
For PCI/PCI-E adapter
WLAN Adapter Physical Connection Diagram
Note
Computer will prompt you to install driver
after the adapter has been inserted.
Please refer to the steps in “Instruction
of Install LAN Adapter Driver”
Quick Installation Guide
300Mbps Wireless N PCI-E Adapter
Information in this docutment is subject to change without prior notice.
For more information, please go to www.hiroinc.com
Copyrights 2015 by HIRO All rights reserved. Website: http://www.hiroinc.com
Step 2: You will see the following screen. Click on the button “Available Networks ”,
double click the network you want to connect in the list of Available Networks
and click Next button .
Step 3: Enter the network key if it is necessary and click Next button to finish.
Step 4: To check the connection, you will see the IP address and Mask of your
computer, point your mouse to the utility icon in the system tray and it will
show Status: “Good”.
H50212
H50212
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment and it also complies with Part 15 of the FCC RF Rules. This equipment
must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and installers must be provided with
antenna installation instructions and consider removing the no-collocation statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Caution!
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC Statement
FCC Radiation Exposure Statement
Model No.: H50296