Omnitracs LLC IVG2 Benutzerhandbuch
80-JE026-1 Rev. J
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
18
Installation Guidelines
Typical Installation Steps
1. Activate the IVG online at least one day prior to installation.
2. Install the power I/O cable then the IVG display.
3. Run system verification.
2. Install the power I/O cable then the IVG display.
3. Run system verification.
Safety, Reliability, and Accessibility
• Use eye protection when using a drill/performing work that may be hazardous to the
eyes.
• Use ear protection in noisy work areas.
• Wear appropriate clothing/uniforms and safety shoes.
• Maintain three points of contact when climbing in and out of cab.
• Make sure you know what is behind the area before you drill.
• Install equipment so it will not cause damage to the vehicle or work loose over time.
• Make sure there are no loose components/cables and no unsecured components.
• Use solid mounting surfaces.
• Route all cables away from hot or abrasive areas.
• Choose installation locations where components can be easily serviced.
• Choose installation locations where components are safe from tampering and damage.
• Wear appropriate clothing/uniforms and safety shoes.
• Maintain three points of contact when climbing in and out of cab.
• Make sure you know what is behind the area before you drill.
• Install equipment so it will not cause damage to the vehicle or work loose over time.
• Make sure there are no loose components/cables and no unsecured components.
• Use solid mounting surfaces.
• Route all cables away from hot or abrasive areas.
• Choose installation locations where components can be easily serviced.
• Choose installation locations where components are safe from tampering and damage.
Tools and Supplies Recommended for Installation
• Crimpers
• Diagonal wire cutters
• Wire strippers
• Screwdrivers: Phillips #2 and slotted
• Torx drivers: #10, #20 and #25
• Volt/Ohm meter
• Flush cutters
• Flash/Drop light
• Diagonal wire cutters
• Wire strippers
• Screwdrivers: Phillips #2 and slotted
• Torx drivers: #10, #20 and #25
• Volt/Ohm meter
• Flush cutters
• Flash/Drop light