Omnitracs LLC IVG2 Benutzerhandbuch
80-JE026-1 Rev. J
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
20
If the power I/O cable connector does not connect to the truck’s diagnostic connector, you
must cut off the Y portion of the power I/O cable and crimp-splice the wires. See Appendix C
General Wiring and Installation Guidelines for instructions.
must cut off the Y portion of the power I/O cable and crimp-splice the wires. See Appendix C
General Wiring and Installation Guidelines for instructions.
Connect the Power I/O Cable
1. With the truck’s ignition off, remove and push back existing truck diagnostic connector;
then check the connector to verify it’s clean of debris and there are no bent pins.
2. Connect the power I/O cable’s mating connector to the truck’s diagnostic connector,
verifying that the outer ring twists-and-clicks into place so that the ends are not
accidentally disconnected; then verify by pull-testing the connector.
accidentally disconnected; then verify by pull-testing the connector.