Troy-Bilt TB330 XP Benutzerhandbuch

The cutting height adjustment lever is located above the left 
rear wheel. To adjust the cutting height, refer to the “Assembly & 
Set-Up” Section.

Your mower’s deck is equipped with a water port on its surface 
as part of its deck wash system. Use the deck wash to rinse grass 
clippings from the deck’s underside.

Your mower is shipped as a mulcher. To discharge the grass 
clippings to the side instead, follow the instructions in the 
“Assembly & Set-Up” section to attach the side discharge chute.

Keep hands and feet away from the 

chute area on cutting deck. Refer to warning label 
on the unit.

The recoil starter is attached to the right upper handle. Stand 
behind the unit and pull the recoil starter rope to start the unit.

The blade control is attached to the upper handle of the mower. 
Depress and squeeze it against the upper handle to operate the 
unit. Release it to stop engine and blade.

This blade control is a safety device. 

Never attempt to bypass its operations.

The drive controls are located on top of the upper handle and are 
used to engage the drive. Squeeze the right, left, or both right 
and left controls against the upper handle to engage the drive; 
release it/them to slow down or stop mower from propelling.

The speed control is located on the variable speed control 
housing on the upper handle. This control is used to select the 
forward speed of the mower. See Fig. 4-1 inset.
IMPORTANT: Move the speed control only when the engine is 
running. Changing the speed control setting with the engine off 
can damage the mower.