Troy-Bilt 1400 Benutzerhandbuch

2. 

Attach the upper handle to the mid handle using one 

carriage screw and handle knob on each side. See Figure 

3-3.
NOTE: Make sure the cord is routed behind the handle 

assembly.

3. 

Ensure that the cord retainer is on the mid handle’s 

crossbar. Refer to Figure 3-2. Place the mid and upper 

handles onto the lower handle. See Figure 3-4.

4. 

Insert wing knobs and carriage bolt and tighten to secure 

upper handle and mid handle to the lower handle. See 

Figure 3-4.

5. 

Secure motor cord to cable guide. See Figure 3-5.
NOTE: The motor cord runs behind the upper handle.

1. 

Remove the four screws securing the front cover to the 

auger housing. Remove the front cover and the chute. See 

Figure 3-6.

2. 

Remove the wing knob, bell washer and bolt from the left 

side of the chute. See Figure 3-7.

3. 

Pivot the upper chute upwards and over the lip and the top 

of the lower chute.

4. 

Reinstall the wing knob, bell washer and bolt.