Troy-Bilt 1400 Benutzerhandbuch

NOTE: Do not plug your extension cord into the power source 

receptacle (outlet) prior to routing it through the cord retainer 

and connecting it to the snow thrower’s power cable.
To properly route your extension cord through the strain reliever:
1. 

Approximately 14 to 16 inches from its end, crease your 

extension cord to form a tight loop.

2. 

Push the loop through the bottom of the strain reliever.

3. 

Position the loop over the clips found on the strain reliever 

and pull down until the cord fits snugly into the clip. Plug 

the snow thrower power cable into the extension cord. See 

Figure 3-10.

NOTE: Use a UL-approved extension cord. A 100-foot, 

14-gauge cord is recommended. A 50-foot, 16-gauge 

cord is acceptable. Refer to the small chart found in Safe 

Operation Practices.

NOTE: When installing the bell washer the concave (or 

cupped) side of the washer must be installed facing the in 

towards the chute.

5. 

Install the chute in the auger housing with the handle 

facing towards the rear of the snow thrower. See Figure 3-8

6. 

Re-install the front cover with the four screws removed in 

step 1. See Figure 3-9.