Troy-Bilt 2620 Benutzerhandbuch

Place the shift lever in the Forward-6 position

1. 

Observe the lower rear area of the snow thrower to be sure 

2. 

both cables are aligned with roller guides before pivoting 

the handle upward. See Fig. 3-1.

NOTE: Make certain the upper ends of each cable are 

seated properly in its bracket.
Secure the handle by tightening the plastic knob located 

3. 

on both the left and right sides of the handle. Remove 

and discard any rubber bands, if present. They are for 

packaging purposes only.

Remove wing nut and hex screw from chute control 

1. 

assembly and clevis pin and cotter pin from chute support 

bracket. Position the chute assembly (forward-facing) over 

the chute base. See Fig. 3-2.
Place chute assembly onto chute base and secure chute 

2. 

control assembly to chute support bracket with clevis pin 

and cotter pin removed earlier. See See Fig. 3-3.

One Snow Thrower

• 

Two Replacement Auger Shear Pins

• 

One Product Registration Card

• 

One Snow Thrower Operator’s 

• 

Manual