Honeywell ADEMCO LYNXR Series Benutzerhandbuch

–5– 

 

The illustration below shows the front assembly separated from the back plate. 

 

!  

 

 

01009-003-V0

MXXXX K5108

16

1

LOCKING TABS

PC BOARD

PART NUMBER

LOCATION

PC BOARD
PART NUMBER
LOCATION

 

 

If desired, an optional mounting base (model LYNX-DM, purchased separately) allows the LYNXR-Series controls to be 
used on a desktop.  

 

01009-004-V1

WIRE ENTRY

KNOCKOUT

(1 of 3)

 

1.  Separate the front assembly from the 

back plate by pressing on the two 
locking tabs at the top of the unit. 

 

2. Carefully disconnect the ribbon cable 

from the front assembly, leaving the 

ribbon cable connected to the 
terminal block PC board. The back 
plate contains the terminal block for 
making wiring connections. 

 

3.  Mount the back plate to a sturdy wall, 

feeding the field wiring through the 
appropriate openings in the back 
plate. 

 

4. After wiring connections are made, 

carefully reconnect the ribbon cable to 

the front assembly PC board 
connector (properly aligning the red 
wire). 

 

5.  Before closing the assembly, verify 

which LYNXR model is being installed 
by checking the model number printed 
on the PC Boards. (Example: 
SALYNXREN indicates the unit being 
installed is a LYNXR-EN.) 

 

6.  Snap the front assembly to the back 

plate so it is secured by the locking 
tabs. 

1. Slide the control panel onto the 

mounting base locking tabs

. 

 

2.  Bring all wiring through the bottom of 

the mounting base, using one of the 
three wire entry locations, before 
making connections to the control 
panel. 

 

3.  Use tie-wraps to secure the wiring to 

the built-in wire loops as needed. Use 
the two supplied screws to secure the 
control panel to the mounting base. 

 

 

Get user manuals: 

See SafeManuals.com