Zebra HW46211 Benutzerhandbuch
Page 4-84
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 4
Maintenance
Options
Install Options
Supply Spindle
1. Refer to
. Turn the printer Off (O) and remove the AC
power cord and communication cables.
2. Refer to
and remove the electronics cover.
3. Refer to
. Remove the font card or memory card from the card slot at the
rear of the printer by removing the option card shield and pressing the card-release
button.
button.
4. Refer to
. Remove any optional interface board
installed.
5. Refer to
. Disconnect all ribbon cable and small wire
connectors from the main logic board, and remove it.
6. Refer to
. Remove the media hanger mounting screw and washer.
7. Remove the media hanger by lifting it straight up then out from the printer frame.
Figure 4-57. Remove Hanger and Install Spindle
8. Install the media supply spindle with support between the shaft and the printer
frame.
9. Install the screw and washer onto the end of the spindle shaft and tighten.
10. Reinstall the main logic board mounting plate.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.
Mounting Screw
Washer
Support
Mounting Screw
Washer
Spindle
Assembly
Hanger