Defender 21031 Benutzerhandbuch
33
To adjust the user name, password and server port for mobile login:
1. Select the column next to the setting you would like to change and a keyboard will appear.
2. Type the user name, password and port you would like then select ENTER to close the keyboard. (User name and
1. Select the column next to the setting you would like to change and a keyboard will appear.
2. Type the user name, password and port you would like then select ENTER to close the keyboard. (User name and
passwords are case sensitive.)
3. Select APPLY from the main camera menu to save your changes.
4. For more information about mobile setup please see MOBILE VIEWING section.
3. Select APPLY from the main camera menu to save your changes.
4. For more information about mobile setup please see MOBILE VIEWING section.
ALARM SETUP
The alarm menu allows you to adjust which alarms you would like set and adjust the length of time that the internal
buzzer will sound for. This DVR gives you the option to have email alerts sent when motion is detected. To set up email
notifications for motion, please see NETWORKING SETUP- EMAIL TAB.
m
otion
t
aB
• CH:
The channel you want motion detection.
• Enable: Enable or disable motion detection.
• Area: Set up the area to be detected by motion.
• Sensitivity:
• Area: Set up the area to be detected by motion.
• Sensitivity:
Use a range from (1-8) to detect object. 1
being the least sensitive and 8 being the
most sensitive.
• Alarm Out:
This DVR does not support this function.
• Alarm Time:
This DVR does not support this function.
• Show Message: DVR will display a message on screen when
motion is detected.
• Buzzer:
Set the length of the buzzer sounding when motion is detected (10s, 20s, 40s, 60s).
• Send Email:
Send an email when motion is detected.
• Full Screen:
When motion is detected on a specific channel, that channel will be switched to full
screen mode.
• Record Channel: The channel will begin recording when motion is detected.
• Post Recording: Set the record length after motion alarm ends (30s, 1 minute, 2 minutes, 5 minutes).
• Copy: Copy your current channel settings to other channels on the DVR.
• Record Channel: The channel will begin recording when motion is detected.
• Post Recording: Set the record length after motion alarm ends (30s, 1 minute, 2 minutes, 5 minutes).
• Copy: Copy your current channel settings to other channels on the DVR.
To change the status of motion detection for each camera:
1. Select the channel you want to have motion detection enabled on.
2. Select ENABLE next to the camera you would like to turn motion detection on/off.
3. Select the drop down menu next to buzzer to set the length of the buzzer sound.
4. Select the boxes next to Show Message and Send Email if you would like these notifications enabled.
5. Select the channels at the bottom by clicking on them if you would like the channel with motion
1. Select the channel you want to have motion detection enabled on.
2. Select ENABLE next to the camera you would like to turn motion detection on/off.
3. Select the drop down menu next to buzzer to set the length of the buzzer sound.
4. Select the boxes next to Show Message and Send Email if you would like these notifications enabled.
5. Select the channels at the bottom by clicking on them if you would like the channel with motion
to be recorded.
6. Select the POST RECORDING drop down box to set up the length of recording after the alarm has ended.
7. Select APPLY to save changes.
7. Select APPLY to save changes.
MAIN MENU