Texas Instruments DLP® LightCrafter™ Evaluation Module DLPLIGHTCRAFTER DLPLIGHTCRAFTER Datenbogen

Produktcode

DLPLIGHTCRAFTER

www.ti.com

Controlling Image Orientation

To change the DLP LightCrafter LED current follow these steps:

1. Type the LED Current Value into the corresponding LED's textbox. The GUI automatically calculates

and displays the LED current in mA.

•

If the value is above 274, a note is added to the LED Current title to inform the user that active
cooling is needed. See

Figure 2-27

Figure 2-27. DLP LightCrafter GUI LED Current Setting Active Cooling Needed

•

If the value is above 758, the value turns red and a note is added to the LED Current title to inform
the user that this is not a recommended setting. See

Figure 2-28

Figure 2-28. DLP LightCrafter GUI LED Current Setting Not Recommended

2. Click the "Set" button as shown in

Figure 2-29

Figure 2-29. DLP LightCrafter GUI LED Current Setting Set Button

3. To retreive the EVM's current LED Current Value, click the "Get" button.

2.5

Controlling Image Orientation

The Image Orientation controls the long- and short-axis flips to support front, rear, table, and ceiling
mounted projection. The Image Orientation takes place after the "Set" button has been clicked.

Figure 2-

shows the "Image Orientation" settings in the GUI.

•

East/West Flip (Short-Axis): If checked, the image is flipped along the east/west axis of the projected
image. Normal table front projection has this setting checked (otherwise, the image is flipped
horizontally).

•

North/South Flip (Long-Axis): If checked, the image is flipped along the north/south axis of the
projected image. Normal table front projection has this setting unchecked (otherwise, the image is
flipped vertically).

DLPU006C – January 2012 – Revised December 2013

Operating the DLP LightCrafter

Submit Documentation Feedback