Texas Instruments DLP® LightCrafter™ Evaluation Module DLPLIGHTCRAFTER DLPLIGHTCRAFTER Datenbogen
Produktcode
DLPLIGHTCRAFTER
Triggering External Peripherals (Camera and So Forth)
Figure 2-31. DLP LightCrafter GUI Output Trigger Settings
To setup the output Trigger, follow these steps:
1. Check the "Enable" checkbox in the Output Trigger Settings as shown in
.
•
The output trigger can only be enabled if the EVM is in either "Stored Pattern Sequence" mode or
"External Streaming Pattern Sequence" while in "HDMI Port" mode.
"External Streaming Pattern Sequence" while in "HDMI Port" mode.
Figure 2-32. DLP LightCrafter GUI Output Trigger Enable Checkbox
2. If an active low trigger output is desired, check the "Invert" checkbox. If an active high trigger output is
desired do not check "Invert"
3. Enter the pulse width and delay in microseconds
•
Pulse Width: width of trigger output pulse in microseconds
•
Delay: number of microseconds pulse is delayed after pattern exposure begins
4. Click "Set" as shown in
.
Figure 2-33. DLP LightCrafter GUI Output Trigger Set Button
33
DLPU006C – January 2012 – Revised December 2013
Operating the DLP LightCrafter
Copyright © 2012–2013, Texas Instruments Incorporated