Texas Instruments 9A, 3V to 4V Vin, SWIFT™ Converter Evaluation Module TPS54917EVM-367 TPS54917EVM-367 Datenbogen
Produktcode
TPS54917EVM-367
Board Layout
www.ti.com
The input decoupling capacitors (C1, C2, and C13) and bootstrap capacitor (C6) are all located as close to
the IC as possible. In addition, the voltage set-point resistor divider components are also kept close to the
IC. The voltage divider network ties to the output voltage at the point of regulation, the copper V
the IC as possible. In addition, the voltage set-point resistor divider components are also kept close to the
IC. The voltage divider network ties to the output voltage at the point of regulation, the copper V
OUT
area
fill near the output connector. For the TPS54917, an additional input bulk capacitor may be required,
depending on the EVM connection to the input supply. A mounting area is provide at C13.
depending on the EVM connection to the input supply. A mounting area is provide at C13.
Figure 11. TPS54917EVM-367 Top-Side Layout
Figure 12. TPS54917EVM-367 Internal Layer 1
10
TPS54917EVM-367 9-A, SWIFT™ Regulator Evaluation Module
SLVU278 – December 2008