Texas Instruments DDC11XEVM-PDK - DDC11xEVM-PDK Evaluation Module DDC11XEVM-PDK DDC11XEVM-PDK Datenbogen
Produktcode
DDC11XEVM-PDK
www.ti.com
DDC11xEVM-PDK Kit Operation
Next, the screen shown in
appears. Verify that the installation directory is correct, and press the
large button in the upper left corner of this screen to proceed.
Figure 18. Choose Software Installation Directory
When the installer completes copying files, the screen shown in
appears.
Figure 19. Software Installation Complete
The software installation is now complete. Disconnect power from the DDCMB and proceed to the next
section.
section.
7.3
Evaluating a DDC11x Device: Quick Start
With power disconnected to the DDCMB, connect one of the daughtercards to the motherboard by directly
connecting the 50-pin header of the daughtercard to the 50-pin socket of the DDCMB.
connecting the 50-pin header of the daughtercard to the 50-pin socket of the DDCMB.
Connect the power supply to the DDCMB (if not connected). To power the daughtercards from the
DDCMB, attach jumpers JP1 and JP2 for the DDC112EVM, and JP2 only for the DDC114EVM. If using
the DDC112EVM, attach jumpers JP1 and JP2 on the DDCMB to supply power to the DDC112EVM.
When not powering the daughtercards from the DDCMB, remove JP1 and JP2 from the DDCMB. The
DDC112EVM requires both 3.3V (J7) and 5V (J6) while the DDC114EVM requires 5V only at J2,
assuming JP1 and JP2 of the DDC114EVM are connected. Turn on the power supply.
DDCMB, attach jumpers JP1 and JP2 for the DDC112EVM, and JP2 only for the DDC114EVM. If using
the DDC112EVM, attach jumpers JP1 and JP2 on the DDCMB to supply power to the DDC112EVM.
When not powering the daughtercards from the DDCMB, remove JP1 and JP2 from the DDCMB. The
DDC112EVM requires both 3.3V (J7) and 5V (J6) while the DDC114EVM requires 5V only at J2,
assuming JP1 and JP2 of the DDC114EVM are connected. Turn on the power supply.
17
SLAU234A – October 2007 – Revised July 2010
DDC11xEVM-PDK User's Guide
Copyright © 2007–2010, Texas Instruments Incorporated