Texas Instruments DDC11XEVM-PDK - DDC11xEVM-PDK Evaluation Module DDC11XEVM-PDK DDC11XEVM-PDK Datenbogen
Produktcode
DDC11XEVM-PDK
www.ti.com
DDC11xEVM-PDK Kit Operation
From the Daughtercard drop-down menu at the top of this screen (
), select the daughtercard
that is attached to the DDCMB. The settings shown on the FPGA Control tab are populated with the
appropriate settings for the device connected.
appropriate settings for the device connected.
Figure 21. Daughtercard Selection
Next, do a system refresh of the FPGA by clicking on the Refresh All button, located in the upper right
corner of this screen. This refresh initializes the system to working defaults, and verifies communication
with the FPGA. When communication is established, the Take Data button is enabled. The software is
now ready to receive data from the DDC.
corner of this screen. This refresh initializes the system to working defaults, and verifies communication
with the FPGA. When communication is established, the Take Data button is enabled. The software is
now ready to receive data from the DDC.
19
SLAU234A – October 2007 – Revised July 2010
DDC11xEVM-PDK User's Guide
Copyright © 2007–2010, Texas Instruments Incorporated