Texas Instruments Development Kit for TM4C129x,Tiva™ ARM® Cortex™ -M4 Microcontroller DK-TM4C129X DK-TM4C129X Datenbogen

Produktcode
DK-TM4C129X
Seite von 2182
in the RSCLKFCFG register, and the MOSC is configured as the Deep-Sleep clock source
in the DSCLKCFG register, then two outcomes are possible:
■ If the PIOSC is still powered in Deep Sleep (using the
PIOSCPD
bit in the DSCLKCFG
register) then the PIOSC is utilized as the clock source when entering Deep Sleep and
the device enters and exits the Deep-Sleep state normally. The MOSC is not used as
the clock source in Deep Sleep.
■ If the PIOSC has been configured to be powered down in Deep Sleep, then the device
can enter the Deep-Sleep state, but cannot exit properly. This situation can be avoided
by programming the MOSC as the Run and Sleep clock source in the RSCLKCFG
register prior to entering Deep Sleep.
To provide the lowest possible Deep-Sleep power consumption as well the ability to wake the
processor from a peripheral without reconfiguring the peripheral for a change in clock, some of the
communications modules have a Clock Control register at offset 0xFC8 in the module register space.
The
CS
field in the Clock Control register allows the user to select the PIOSC or ALTCLK as the
clock source for the module's baud clock. When the microcontroller enters Deep-Sleep mode, the
PIOSC or ALTCLK becomes the source for the module clock as well, which allows the transmit and
receive FIFOs to continue operation while the part is in Deep-Sleep. Figure 5-6 on page 252 shows
how the clocks are selected.
Figure 5-6. Module Clock Selection
Deep Sleep
Module Clock
System Clock
Clock Control Register
PIOSC or
ALTCLK
Baud Clock
0
0
1
1
Additional power management modes are available that lower the power consumption of the
peripheral memory, Flash, and SRAM memory. However, the lower power consumption modes
have slower deep-sleep and wake-up times.
5.2.6.4
Dynamic Power Management
In addition to the Sleep and Deep-Sleep modes and the clock gating for the on-chip modules, there
are several additional power mode options that allow the LDO, Flash memory, and SRAM into
December 13, 2013
252
Texas Instruments-Advance Information
System Control