Texas Instruments CC2650DK Benutzerhandbuch
PRCM Registers
6.2.3.12 OSCCFG Register (Offset = 38h) [reset = X]
OSCCFG is shown in
and described in
.
Oscillator Configuration This register sets the period for Amplitude compensation requests sent to the
oscillator control system. The amplitude compensations is only applicable when XOSC_HF is running in
low power mode.
oscillator control system. The amplitude compensations is only applicable when XOSC_HF is running in
low power mode.
Figure 6-78. OSCCFG Register
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
RESERVED
R-X
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
RESERVED
PER_M
PER_E
R-X
R/W-X
R/W-X
Table 6-82. OSCCFG Register Field Descriptions
Bit
Field
Type
Reset
Description
31-8
RESERVED
R
X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
other value than the reset value may result in undefined behavior.
7-3
PER_M
R/W
X
Number of 32 KHz clocks between oscillator amplitude calibrations.
When this counter expires, an oscillator amplitude compensation is
triggered immediately in Active mode. When this counter expires in
Powerdown mode an internal flag is set such that the amplitude
compensation is postponed until the next recharge occurs. The
Period will effectively be a 16 bit value coded in a 5 bit mantissa and
3 bit exponent PERIOD=(PER_M*16+15)*2^PER_E This field sets
the mantissa Note: Oscillator amplitude calibration is turned of when
both this bitfield and PER_E are set to 0
When this counter expires, an oscillator amplitude compensation is
triggered immediately in Active mode. When this counter expires in
Powerdown mode an internal flag is set such that the amplitude
compensation is postponed until the next recharge occurs. The
Period will effectively be a 16 bit value coded in a 5 bit mantissa and
3 bit exponent PERIOD=(PER_M*16+15)*2^PER_E This field sets
the mantissa Note: Oscillator amplitude calibration is turned of when
both this bitfield and PER_E are set to 0
2-0
PER_E
R/W
X
Number of 32 KHz clocks between oscillator amplitude calibrations.
When this counter expires, an oscillator amplitude compensation is
triggered immediately in Active mode. When this counter expires in
Powerdown mode an internal flag is set such that the amplitude
compensation is postponed until the next recharge occurs. The
Period will effectively be a 16 bit value coded in a 5 bit mantissa and
3 bit exponent PERIOD=(PER_M*16+15)*2^PER_E This field sets
the exponent Note: Oscillator amplitude calibration is turned of when
both PER_M and this bitfield are set to 0
When this counter expires, an oscillator amplitude compensation is
triggered immediately in Active mode. When this counter expires in
Powerdown mode an internal flag is set such that the amplitude
compensation is postponed until the next recharge occurs. The
Period will effectively be a 16 bit value coded in a 5 bit mantissa and
3 bit exponent PERIOD=(PER_M*16+15)*2^PER_E This field sets
the exponent Note: Oscillator amplitude calibration is turned of when
both PER_M and this bitfield are set to 0
506
Power, Reset, and Clock Management
SWCU117A – February 2015 – Revised March 2015
Copyright © 2015, Texas Instruments Incorporated