Texas Instruments BUF12800 Evaluation Module BUF12800EVM BUF12800EVM Datenbogen
Produktcode
BUF12800EVM
BUF12800EVM Hardware
3.5
Connecting the USB Cable to the USB DIG Platform
Once power is connected, the USB cable must be connected to the DIG, as shown in
.
Figure 7. Connecting the USB Cable to the USB DIG Platform
Note that the Test Board and USB DIG Platform must be powered on before connecting the USB cable.
Typically, the computer responds with a Found New Hardware, USB Device pop-up dialog. The popup
window typically changes to Found New Hardware, USB Human Interface Device. This pop-up window
indicates that the device is ready to be used. The USB DIG Platform uses the human interface device
drivers that are part of the Microsoft
Typically, the computer responds with a Found New Hardware, USB Device pop-up dialog. The popup
window typically changes to Found New Hardware, USB Human Interface Device. This pop-up window
indicates that the device is ready to be used. The USB DIG Platform uses the human interface device
drivers that are part of the Microsoft
®
Windows
®
operating system.
In some cases, the Windows Add Hardware wizard is shown. If this prompt appears, allow the system
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows then confirms installation of the drivers with the message shown in
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows then confirms installation of the drivers with the message shown in
.
Figure 8. Confirmation of USB DIG Platform Driver Installation
8
BUF12800EVM Evaluation Board and Software Tutorial
SBOU116
–
September 2011
Copyright
©
2011, Texas Instruments Incorporated