Insys GSM Small 11-02-01-03-02.001 Benutzerhandbuch
Produktcode
11-02-01-03-02.001
5. Configuration Software HSComm
23
Detect field strength intensity
The actual field
strength of the
GSM signal is
read out and
displayed
graphically.
Values below 12
indicate an insufficient signal strength. The antenna location should be improved. The
value 99 stands for not ascertainable field strength, e.g. due to network loss or a
damaged antenna. When the location of the antenna is changed, it takes approximately
5 to 10 seconds until the field strength of the INSYS GSM small is updated.
The actual field
strength of the
GSM signal is
read out and
displayed
graphically.
Values below 12
indicate an insufficient signal strength. The antenna location should be improved. The
value 99 stands for not ascertainable field strength, e.g. due to network loss or a
damaged antenna. When the location of the antenna is changed, it takes approximately
5 to 10 seconds until the field strength of the INSYS GSM small is updated.
5.2.2 System Monitoring
Software reset
Using a software reset, the INSYS GSM small unregisters for a short period and re-
registers again daily to allow maintenance functions of the GSM provider. Enter the time
interval after which another software reset should be performed (1 to 999 hours).
Afterwards, the INSYS GSM small re-registers at the GSM network, if the PIN of the SIM
card is stored.
For the value “0” no software reset is performed.
Attention! When the INSYS GSM small has not been registered for a longer period, it
Using a software reset, the INSYS GSM small unregisters for a short period and re-
registers again daily to allow maintenance functions of the GSM provider. Enter the time
interval after which another software reset should be performed (1 to 999 hours).
Afterwards, the INSYS GSM small re-registers at the GSM network, if the PIN of the SIM
card is stored.
For the value “0” no software reset is performed.
Attention! When the INSYS GSM small has not been registered for a longer period, it
can not update the updates from the GSM network provider and some
functions may have errors.
functions may have errors.
5.2.3 Connection Protocol
For a data connection with a device outside the GSM network (analog modem or ISDN
TA) the right protocol has to be selected. This setting is not important for data
connections with a GSM device.
TA) the right protocol has to be selected. This setting is not important for data
connections with a GSM device.
Version 1.00 / 09.04