Freescale Semiconductor Xtrinsic MAG3110 Magnetometer Kit LFSTBEB3110 LFSTBEB3110 Benutzerhandbuch

6

Freescale Semiconductor

 

1. Ensure that the compass boards are connected to a USB port on your PC with the USB cable.

The evaluation board’s red power LED illuminates. (If the LED does not illuminate, check the 
power switch located next to the board’s USB connector.)

2. Launch the toolbox software by doing either of the following:

— Double-click on the application’s desktop icon

— Select Start > Programs > Sensor Toolbox > Sensor Toolbox

The sensor toolbox’s hardware-detection dialog box, shown below, displays.

Then the MAG3110 evaluation software’s main menu, shown in the following figure, displays.

3. Open the tilt-compensated eCompass application by clicking on Full System Evaluation.