Freescale Semiconductor Xtrinsic MAG3110 Magnetometer Kit LFSTBEB3110 LFSTBEB3110 Benutzerhandbuch

8

Freescale Semiconductor

 

When the device is successfully calibrated, as shown in the following figure, the Calibrated frame 
displays:

— A Fit Error % that should be less than 2%

— Five green bars, where the red-magnet icon had appeared

— The message Calibrated, at the bottom of the frame

3. Take one of the following actions with the established calibration:

— To freeze the current calibration, clear the Track checkbox

— To update the calibration continuously, enable the Track checkbox

4. Review the readings in the Magnetometer B, Accelerometer g, and Calibrated B frames, shown in 

the following figure, that are located in the top, left corner of the Main screen.

— The Magnetometer B frame shows the three components of the magnetic field in µT measured 

by the magnetometer sensor

— The Accelerometer g frame shows the three components of the accelerometer sensor output 

measured in mg

— The Calibrated B frame shows the magnetometer output corrected by the magnetic calibration 

and corrected for the tilt of the evaluation board