Freescale Semiconductor MC56F8006 Demo board MC56F8006DEMO MC56F8006DEMO Datenbogen
Produktcode
MC56F8006DEMO
Signal/Connection Descriptions
MC56F8006/MC56F8002 Digital Signal Controller, Rev. 4
Freescale Semiconductor
19
GPIOA3
(PWM3)
(TXD)
(EXTAL)
17
24
20
36
Input/
Output
Output
Output
Analog
Input
Input,
internal
pullup
enabled
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
an input or output pin.
PWM3 — The PWM channel 3.
TXD — The SCI transmit data output or transmit/receive in single
wire operation.
wire operation.
EXTAL — External Crystal Oscillator Input. This input can be
connected to a 32.768 kHz or 1–16 MHz external crystal or ceramic
resonator. When used to supply a source to the internal PLL, the
crystal/resonator must be in the 4 MHz to 8 MHz range. Tie this pin
low or configure as GPIO if XTAL is being driven by an external
clock source.
connected to a 32.768 kHz or 1–16 MHz external crystal or ceramic
resonator. When used to supply a source to the internal PLL, the
crystal/resonator must be in the 4 MHz to 8 MHz range. Tie this pin
low or configure as GPIO if XTAL is being driven by an external
clock source.
If using a 32.768 kHz crystal, place the crystal as close as possible
to device pins to speed startup.
to device pins to speed startup.
After reset, the default state is GPIOA3.
GPIOA4
(PWM4)
(SDA)
(FAULT1)
(TIN2)
16
22
18
33
Input/
Output
Output
Input/Open-
drain
Output
Input
Input
Input,
internal
pullup
enabled
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
an input or output pin.
PWM4 — The PWM channel 4.
SDA — The I
2
C serial data line.
FAULT1 — PWM fault input 1used for disabling selected PWM
outputs in cases where fault conditions originate off-chip.
outputs in cases where fault conditions originate off-chip.
TIN2 — Dual timer module channel 2 input
After reset, the default state is GPIOA4.
GPIOA5
(PWM5)
(FAULT2/
EXT_SYNC)
(TIN3)
14
20
16
29
Input/
Output
Output
Input/
Output
Input
Input,
internal
pullup
enabled
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
an input or output pin.
PWM5 — The PWM channel 5.
FAULT2 — PWM fault input 2 used for disabling selected PWM
outputs in cases where fault conditions originate off-chip.
EXT_SYNC — When not being used as a fault input, this pin can be
used to receive a pulse to reset the PWM counter or to generate a
positive pulse at the start of every PWM cycle.
outputs in cases where fault conditions originate off-chip.
EXT_SYNC — When not being used as a fault input, this pin can be
used to receive a pulse to reset the PWM counter or to generate a
positive pulse at the start of every PWM cycle.
TIN3 — Dual timer module channel 3 input
After reset, the default state is GPIOA5.
Table 5. 56F8006/56F8002 Signal and Package Information (continued)
Signal
Name
28
SOIC
32
LQFP
32
PSDI
P
48
LQFP
Type
State
During
Reset
Signal Description