Weidmueller Weidmüller 1175980000 ACT20M-CI-CO-S Measuring Transducer Content: 1 pc(s) 1175980000 Datenbogen
Produktcode
1175980000
Datenblatt
Erstellungs-Datum December 17, 2013 12:58:05 PM CET
Katalogstand xx.xx.xxxx / Technische Änderungen vorbehalten
1
ACT20M
ACT20M-CI-CO-S
Weidmüller Interface GmbH & Co. KG
Klingenbergstraße 16
D-32758 Detmold
Germany
Fon: +49 5231 14-0
Fax: +49 5231 14-292083
www.weidmueller.com
General ordering data
Type
ACT20M-CI-CO-S
Order No.
Version
ACT20M, Signal converter/disconnector, Screw
connection
GTIN (EAN)
4032248970131
Qty.
1 pc(s).
The externally supplied ACT20M-CI-CO, MAS RPS/RPSH,
MCZ CFC and WAS/WAZ 4/5 C signal converters/
supply isolators can transmit, isolate and convert
standardised
DC current signals. They are optionally available in widths
of 6 mm (ACT20M/MCZ), 12.5 mm (WAS/WAZ4) or
17.5 mm (WAS/WAZ5).
The input and output circuits are completely electrically
isolated, as is the power supply.
The input signal is converted into a DC current/voltage
value (ACT20M, WAS/WAZ) or into a proportional
frequency (MCZ CFC) between 0–1/4/8/16 kHz.
The WAVESERIES signal converters are available with
a limiting frequency of either 10 Hz (WAS/WAZ4) or
20 kHz (WAS/WAZ5) so that they can process signals
quickly.
The MAS/RPS/RPSH supply isolator can supply 2-wire
sensors externally. They can also be used optionally to
transmit the HART protocol (MAS RPSH).
The 24 VDC supply voltage can be cross-connected on
the module side via the CH20M BUS profile (ACT20M
series) or using the ZQV4N (MAS/MCZ) or ZQV 2.5N
(WAS/WAZ) pluggable jumpers.
International approvals (such as ATEX Zone 2, UL C1D2
and FM Div2) permit use in explosion-risk zones.