Panasonic Limit switch 125 Vac 0.1 A Tappet momentary AZH2332CEJ IP67 1 pc(s) AZH2332CEJ Datenbogen

27

The cord outlet direction is interchange-
able both right and left sides. The direc-
tion of connector cord is set to the right
when it is shipped. When it is used left
side direction, follow the next procedure.

Cord outlet direction (Right side)

Cord outlet direction (Left side)

Push down the fitting metal while pulling
it horizontal direction.

Confirm the fitting metal is on tightly.
If it is loosen, it might be cause of the
trouble.

• Do not put the lead wire between termi-
nal cover and body.
• Put the seal rubber at the right place.
• Press up the terminal cover.

Turn the terminal cover at an angle of
180 degree. Follow the procedure 3.
• Do not pull the terminal cover.
• Do not rotate the terminal cover many
times.
• Do not loosen the terminal screw.

1) See the circuit diagram.
2) Voltage across the terminal No. 3 and
No. 4 shall not exceed 24 V DC, with the
indicated polarity in the circuit diagram.
3) The LED is turned on when the switch
is at a free position. The LED is turned
off when the switch operates.

4) Applicable power source is 24 V DC.
Use it with care on leakage current. The
leakage current is approx. 1.5 mA at 24
V DC.

Internal circuit

Body

Fitting metal

Terminal cover

Step 1

Seal rubber

Step 3

Attention

Attention

Step 4

Cramp

Step 2

Contact No. 2

Switch

Contact No. 4

Contact No. 3

LED

+

−

Resistance

Load

HL (AZH)

04/2005